Cut Wire

The process of sand blasting is used to remove paint and other baked on coatings or organic coatings, but new media is used that is far more effective, environmentally-friendly and cost-effective rather than the fine sand that is commonly used. For example, nylon pellets to cut wire and de-flash electrical and electronic components is a far better option because it can easily be removed afterwards from small apertures. When parts are electro-coated there must be absolute electrical contact between materials for effective current flow so cut wire and de-flashing methods are used to make sure that all organic materials are removed that will decrease conductivity. Chemicals to cut wire and stripping are impractical and nylon pellets and other plastic media are far more effective, plus they can remove coatings layer by layer.

Special equipment is used for material stripping normally in enclosures that will keep the media contained and re-circulating for reuse. No doubt you have heard about the sandblasting process that has been common over the years to strip paints and other coatings from metal. The problem using fine sand particles is that it is apt to pock mark and pit metals, and removing minute particles of sand afterwards can be a chore. To clean electrical surfaces and cut wire de-flashing nylon pellets or plastic grit are a far better option, and you can read some technical data that will give you the reasons why on our website. Our products are used in a spectrum of industries, from automotive to aeronautical, with solutions in materials for many different stripping machines.

Composition Material (Composition materials) has a variety of solutions, not only for organic surfaces removal, but also for fillers for a variety of different purposes. We are the largest importer and supplier of birch wood flour, cut wire media, fillers, extenders walnut shell grits, and plastics and nylon pellets worldwide. Our selection of over 200 products in our inventory is suitable for a variety of different machines and you are welcome to contact an expert technical consultant so that they can make practical suggestions of what is the best option to cut wire or clean surfaces from plastic to metals. Talk to us for the right materials to cut wire and electronic de-flashing or for whatever purposes you have in mind and get the most cost effective solution available from us.